Skip to the content

Fitting guide

Everything you need to lay an interlocking floor yourself, from bare concrete to the last edge ramp.

Step by step

From bare concrete to a finished floor

Allow an afternoon for a single garage with two people. You need a rubber mallet, a tape measure, a pencil and a jigsaw or fine-tooth saw.

  1. Clear and sweep

    Empty the garage and sweep the floor clean. Grit left under a tile stops it sitting flat.

  2. Check the concrete

    The tiles follow what is underneath. Hairline cracks and stains are fine; fill any hollow deeper than a few millimetres and let it set.

  3. Plan the pattern

    Sketch the floor on paper, a square for each tile, if you are mixing colours. Unpack the boxes by colour so you are not hunting mid-row.

  4. Start in the far corner

    Lay the first tile in the corner furthest from the door with its loops facing into the room, then work in rows towards the entrance.

  5. Lock each joint

    Set the tabs over the loops and tap down along the joint with a rubber mallet until the two tiles sit flush.

  6. Cut the last row

    Measure to the wall, leave a 5 mm gap for expansion, mark the tile and cut it with a jigsaw or fine-tooth saw.

  7. Fit the edge ramps

    Clip ramps along every open edge you drive or wheel a trolley over, so nothing catches the edge of a tile.

Tile calculator

Measure, then order once

Wall to wall, in metres. The spares cover cuts round posts, drains and door frames.

Floor area
0 m²
Tiles, with spares
0
Packs of 25
0

Mixing colours? Work out the area of each colour separately and add a few spares to each.

Finished floors

What you are aiming for

Vented tiles in two greys, laid as a checkerboard
Vented tiles in two greys, laid as a checkerboard
A detailing bay, wall to wall in one pattern
A detailing bay, wall to wall in one pattern
Light and dark grey under a satin-black car
Light and dark grey under a satin-black car

Questions

While you are laying

Do the tiles need to acclimatise?

Leave the boxes open in the garage for a day before you lay them, so the tiles are at the temperature of the room. Plastic moves a little with heat and cold.

Why leave a gap at the walls?

A 5 mm gap gives the floor room to move as the temperature changes, so it never pushes up against a wall and lifts.

Can I lay tiles over a painted or epoxy floor?

Yes, as long as the surface underneath is sound and dry. The tiles are not fixed to it, so they will not pull flaking paint up with them.

What if I damage a tile?

Unclip the tiles around it, lift it out and lock a spare in its place. Keep two or three from your order for exactly this.

Ready to order?

Tiles, edge ramps and sample packs, delivered to UK addresses.

Staging

This is your staging site — it is not your live website. Changes land here first so you can check them before the public sees them.